The IP67 rated LD151 buried uplighter is a very powerful luminaire for its size and depth.
Available in Warm White, White and Red/Green/Blue/White (RGBW). See below for driver and control requirements for this.
With no visible fixings the LD151 is held into the sleeve or concrete housings by ‘O’ rings. This creates a watertight seal (to protect against water ingress in to the floor below) and allows the fitting to be installed after the completion of all construction and decoration work. It also facilitates future maintenance.
It is imperative that any connections made in wet environments are IP68 rated. So for example if using the fittings with the concrete housing outside, you must ensure that the connections made with the driver are properly water tight. Comes pre-wired with a 2 core 100mm cable.
The LD151 is a constant current fitting which requires a driver to run it, drivers can run multiple fittings but fittings must be wired in series
With an appropriate driver the fitting is dimmable via 0-10V, DALI and Mains leading/trailing edge or non-dim. Please select dimming type on options tab above and that will take you through to a page detailing how many fittings you can run per driver
The fittings should be wired in series, and the cable run between the driver and the fittings shouldn't exceed 10m. The driver should be located somewhere discrete, allowing air movement, and accessible for maintenance.
N.B. Please read The Lighting Buyer's Technical Reference Guide for recommendations and watch-outs around different dimming methods and LED wiring.
|LD151 Data Sheet Size: (739.55 KB)|