A small fitting with a very deep recessed LED position and with a small aperture resulting in an uplight with little or no glare. It can be can be used as an uplighter or downlighter and is ideal for doorways, narrow corridors or wall washing. It’s sealed to IP68 so can be used outside, integral anti wicking barrier increases protection against moisture ingress due to incorrect IP rated cable connections.
Note that due to the small size of the aperture it is only available with a narrow 12° optic.
An optional glare shield is available to further reduce glare from the LED and optic, which is particularly useful where people are going to be directly over the fitting. This does not reduce the light on the lit surface (wall) but will cut out some light onto the ceiling.
See the product spec sheet in Resources for fixing options. Comes pre-wired with a 2 core 100mm cable.
The higher the current (mA) the fitting is run at the more light you will get but the warmer the fitting gets.
The LD43DR is a constant current fitting which requires a driver to run it, drivers can run multiple fittings but fittings must be wired in series
With an appropriate driver the fitting is dimmable via 0-10V, DALI and Mains leading/trailing edge or non-dim. Please select dimming type on options tab above and that will take you through to a page detailing how many fittings you can run per driver
The fittings should be wired in series, and the cable run between the driver and the fittings shouldn't exceed 10m. The driver should be located somewhere discrete, allowing air movement, and accessible for maintenance.
N.B. Please read The Lighting Buyer's Technical Reference Guide for recommendations and watch-outs around different dimming methods and LED wiring.
There are currently no resources for this product.