A small, tough, low glare fitting which can be used for uplighting, wall washing or step lighting. It’s sealed to IP68 so can be used outside and the integral anti-wicking barrier increases protection against water ingress due to incorrect IP rated cable connections.
An optional glare shield is now available to further reduce glare from the LED and optic. This is really only necessary in narrow details where people are going to be directly over the fitting. This does not reduce the light on the lit surface (wall) but will cut out some light onto the ceiling.
See the product spec sheet in Resources for fixing options. Comes pre-wired with a 2 core 100mm cable.
The higher the current (mA) the fitting is run at the more light you will get but the warmer the fitting gets.
The LD56 is a constant current fitting which requires a driver to run it, drivers can run multiple fittings but fittings must be wired in series
With an appropriate driver the fitting is dimmable via 0-10V, DALI and Mains leading/trailing edge or non-dim. Please select dimming type on options tab above and that will take you through to a page detailing how many fittings you can run per driver
The fittings should be wired in series, and the cable run between the driver and the fittings shouldn't exceed 10m. The driver should be located somewhere discrete, allowing air movement, and accessible for maintenance.
N.B. Please read The Lighting Buyer's Technical Reference Guide for recommendations and watch-outs around different dimming methods and LED wiring.
|LD56 Data Sheet Size: (985.41 KB)|