A very sleek, powerful ground recessed uplight with the LED set deep behind a black baffle for reduced glare.
Using the same light engine as the Quad range of downlights, it delivers a punchy 948 lumens with a Quad 70 engine.
The housing is machined in the UK out of grade 304 stainless steel.
Currently recommended for internal use only: it is IP65 rated from the front but the back is not sealed.
If mounting in to a solid floor (eg; a concrete screed) provision needs to be made for the fittings at an early stage, before any Underfloor Heating pipes are laid or concrete is poured. They basically need an appropriately sized space left for them in the floor: this can be done in a variety of ways including shuttering, or using lengths of appropriately sized drain pipe in the intended fitting locations. It is advisable to make the void space bigger than the fitting diameter to allow for final location adjustments when the fittings are actually installed.
Use with 700mA constant current LED Drivers. Requires one driver per fitting, located remotely within 25m somewhere discrete, allowing air movement, and accessible for maintenance.
Use a non-dim driver, or dimmable with a 1-10v driver or a Mains trailing edge driver.
1-10v dimming requires both a power cable and a 1-10v control cable (often Cat5) to be run between the driver and the 1-10v dimmer module.
Mains trailing edge dimming requires no additional control cable between the dimmer module and the driver. The Quad range of fittings dim excellently using a combination of Quad fitting + recommended mains dimming driver + recommended Quad dimmer.
N.B. Please read The Lighting Buyer's Technical Reference Guide for recommendations and watch-outs around different dimming methods and LED wiring.
|Harvard 1-10 Driver Size: (1.18 MB)|
|Mains Dim (Lightech) Driver Size: (252.76 KB)|
|Non Dim (Meanwell) Driver Size: (798.85 KB)|
|Quad Recessed Uplight Data Sheet Size: (1.43 MB)|